Edge launch SMAs can short into the internal copper layers with some installation methods. Watch for these gotchas.
Category Archives: Ultrasonics
Flagship DL01: Continuous Acquisition with Overridden Tx Gain
As of now 7/5/24 with customer interface software with the DL0100A1, you can stream data in continuous acquisition mode with the higher (max override) transmit gains (Tx gains aka pulse voltages) using the following steps:
Flagship DL01: “Damping” Section: Values and Selections
You could call this part of the board by various names, most of which are printable. Here, we’re just calling it “damping”. It’s rudimentary and is there to be adjusted across assembly variants and system needs, with some basic runtime operability. It can tune the output and cable/XD interface a bit. Mostly, from early work, …
Continue reading “Flagship DL01: “Damping” Section: Values and Selections”
Flagship DL01: Pulse Voltage Table
Tx Gain Setting DL-200V DL-300V DL-500V 0 42 64 103 1 57 85 141 2 71 107 180 3 88 131 224 4 123 182 320 5 147 218 387 6 219 323 585 7 270 408 (!) Gain setting to “tank” voltage table. Please see notes below. Important details follow – please click read …
GXN Swappable HIVDC Module External Voltage Control
The DL0102GXN (“GXN”) can be configured for external HIVDC (Tx/pulse voltage) control. Here are the operating methods and parameters.
DacqMan + RS104 (IS-Target / Low Energy)
Here’s the quick start guide on how to acquire data with DacqMan running the RS104 (IS-Target, Low Energy) UT Scanner. This guide here includes just the basic steps. Really, just a few clicks to start your scan runs.
Firmware Flash Cables
Software programming tools and the programming cable with an adapter, if needed, are used to update the firmware on the DL and HDL family hardware.
IF2C (MUX) Build 2021C Information & Customization
The HDL-0108-IF2C (originally an accessory for the 102GXN, also usable as a multiplexer for the DLITE-0100A1) assembly/build has been modified in the 2021C build variant to minimize input losses for particular use-cases.
ADMPlex Integration
The ADMPlex interfaces directly on the DL0100A1 board, matching its form factor, and hosts up to four (4) separate ADMM client boards.