Here’s the quick start guide on how to acquire data with DacqMan running the RS104 (IS-Target, Low Energy) UT Scanner. This guide here includes just the basic steps. Really, just a few clicks to start your scan runs.
Category Archives: HDL-0104-RS104
Firmware Flash Cables
Software programming tools and the programming cable with an adapter, if needed, are used to update the firmware on the DL and HDL family hardware.
RS104 (HDL-0104-RS104): Starter Kit
The “RS104” (short for HDL-0104-RS104), an electronics hardware prototype, is a 4-channel rapid scan UT-for-NDT device targeting compact, isolated, low-energy point-of-application scanning that also requires wired connectivity.
HDL-0104-RS104: Wire-to-Board Connections (Power and Communications)
The HDL-0104-RS104 is a prototype 4-channel rapid scan ultrasonics-for-NDT board for embedded applications that includes RS-485 communications, additional circuit protection components, and an isolated design. This article covers the basics of wire to board connections.
DL0100A1 vs RS8 vs RS104: Comparison
These two 8-Channel and 1 4-Channel ultrasonic (UT) pulser-receivers for non-destructive testing (NDT) boards share several characteristics and also target very different use-cases. That is, each is optimized for different applications.