As of now 7/5/24 with customer interface software with the DL0100A1, you can stream data in continuous acquisition mode with the higher (max override) transmit gains (Tx gains aka pulse voltages) using the following steps:
Category Archives: Firmware
Flagship DL01: “Damping” Section: Values and Selections
You could call this part of the board by various names, most of which are printable. Here, we’re just calling it “damping”. It’s rudimentary and is there to be adjusted across assembly variants and system needs, with some basic runtime operability. It can tune the output and cable/XD interface a bit. Mostly, from early work, …
Continue reading “Flagship DL01: “Damping” Section: Values and Selections”
Firmware Flash Cables
Software programming tools and the programming cable with an adapter, if needed, are used to update the firmware on the DL and HDL family hardware.
ADMPlex Integration
The ADMPlex interfaces directly on the DL0100A1 board, matching its form factor, and hosts up to four (4) separate ADMM client boards.
DL0100A1: SD Card Support
RS104 (HDL-0104-RS104): Starter Kit
The “RS104” (short for HDL-0104-RS104), an electronics hardware prototype, is a 4-channel rapid scan UT-for-NDT device targeting compact, isolated, low-energy point-of-application scanning that also requires wired connectivity.
Exact Tx-Rx Timing in DL-Family Hardware
Examples of how to assess and change transmit pulse and receive signal timing in the DLITE0100A1 firmware. This is a “flash” post: very quick, draft. You can also probe signals, both digital and analog, at various points on the hardware to get a real-world assessment. Nominally, the Rx Delay implementation has an offset and scale …
DLITE0100A1 Jumper (Shunt) Settings
Several jumpers or shunts on the board, typically placed in default locations, control configurable functionality and provide several implementation options and/or options for experimentation with the board. DL0100A1 (for short) is an 8-channel ultrasonic-for-NDT pulser-receiver board. In this article, photos are omitted by design.
DL0100A1 vs RS8 vs RS104: Comparison
These two 8-Channel and 1 4-Channel ultrasonic (UT) pulser-receivers for non-destructive testing (NDT) boards share several characteristics and also target very different use-cases. That is, each is optimized for different applications.
MAC OS X 10.15 (Catalina) Fresh + Atom IDE + apio
This note came out of a few specific installations where the installation methods didn’t quite work to allow Atom IDE / apio-ide (package) to run its commands, like Verify, Build and Upload, etc.