These two 8-Channel and 1 4-Channel ultrasonic (UT) pulser-receivers for non-destructive testing (NDT) boards share several characteristics and also target very different use-cases. That is, each is optimized for different applications.
Category Archives: DL0100A1
ADMM-CP (VOM): R41 and High Source Impedance
Under conditions of very high source impedance or conditions that create a ground loop (other conditions apply as well), you may want to try removing R41 from the ADMM-CP (VOM) board (or testing with a board that doesn’t have it installed); if, after firmware updates and confirmation of measurement protocol, measurement values still seem inaccurate, …
Continue reading “ADMM-CP (VOM): R41 and High Source Impedance”
XD Conn IFace: DL0100A1 Coax-to-Alternative-Connection Module
This prototype module connects to the DLITE-0100A1 (DL0100A1) board to allow you to wire transducers to the board using direct tinned bare wire connection to screw terminal blocks, or even cables terminated in RJ45 plugs (two are required to connect to the 8 channels). [This article stub is in progress – please inquire directly about …
Continue reading “XD Conn IFace: DL0100A1 Coax-to-Alternative-Connection Module”
IF2C: G(XN)-Hosted Continuous Acquisition
What about using the DL0102G/XN (the “G” and “GXN”) with or without the IF2C in Continuous Acquisition mode in your UT software? In Brief: Yes.