Edge launch SMAs can short out to the internal copper layers as a result of some preparation and installation methods. Watch for these gotchas if you don’t like board shorts. These shorts can create hard-to-diagnose or hard-to-locate power sinks, blown fuses, blown protection diodes, and localized or broad board heating.
Category Archives: Connector Interface
ADMPlex Integration
The ADMPlex interfaces directly on the DL0100A1 board, matching its form factor, and hosts up to four (4) separate ADMM client boards.
XD Conn IFace: DL0100A1 Coax-to-Alternative-Connection Module
This prototype module connects to the DLITE-0100A1 (DL0100A1) board to allow you to wire transducers to the board using direct tinned bare wire connection to screw terminal blocks, or even cables terminated in RJ45 plugs (two are required to connect to the 8 channels). [This article stub is in progress – please inquire directly about …
Continue reading “XD Conn IFace: DL0100A1 Coax-to-Alternative-Connection Module”