This DL ADMM R04 accessory module prototype is an initial concept proof for end-to-end system integration, deployed for initial system proofing circa 10 years ago (as of this writing), meeting an end-user program requirement. A Rev 05 and New Model for 2026 deployment are in development now. It’s functionality depends heavily on how the board …
Category Archives: Calibration
Flagship DL01: Pulse Voltage
This post will indicate how you can measure the voltage available for pulsing the transducer for different settings. BUT, there are important considerations in understanding what the transducer actually experiences.
Exact Tx-Rx Timing in DL-Family Hardware
Examples of how to assess and change transmit pulse and receive signal timing in the DLITE0100A1 firmware. This is a “flash” post: very quick, draft. You can also probe signals, both digital and analog, at various points on the hardware to get a real-world assessment. Nominally, the Rx Delay implementation has an offset and scale …
ADMM-CP (VOM): Attenuated Mode
What it does The attenuated mode takes a real input voltage in the range of around +/- 14VDC and divides it down by about a factor of 10 so that it fits within the on-board ADC’s measurable voltage range of about +/- 1.4VDC. This is nominally and roughly. In a more detailed look, you might …